Check your radiators are heating to the top. If they aren’t, the chances are you need to learn how to bleed a radiator. It sounds a bit medieval, but all it means is releasing the trapped air at the top, which is stopping the hot water from rising. Simply use a radiator bleed key (about £1 in any DIY shop) to open the little valve at the top. You’ll hear air hiss and as soon as you see a drip of water, close it up again. Bingo. Energy-efficient radiators.
When your Peter Brown engineer is performing a power flush, they’ll connect the special equipment needed to your central heating. We don’t need to take off any of your radiators to complete your power flush successfully. Special power flush cleaning fluid is pumped through your system and that begins to loosen the gunge and the rust that’s built up. If your radiator has cold spots, that’s where a build up of unwanted material has occurred and the power flush will quickly remove it. The sludge and the rust then start to come out of the radiator which your engineer will collect and dispose of it. Once your engineer is confident that they have removed everything from your system, they’ll flush it again until the water coming out of the radiators is clean and is acid- and alkali-neutral. The final touch is to flush the radiators again with a protecting fluid to impede any future build-up of sludge and rust. Discover more info on https://www.peterbrown.net/harrow-power-flushing.html.
Insulate your pipes: Insulating your hot water pipes is a quick and easy way to save energy. As well as reducing heat loss from your system, pipe lagging will also prevent pipes from getting too cold in winter, and therefore prevents pipes bursting. Pipe insulation is an easy DIY install – you can buy foam insulation tubes online or from a DIY store and slip them over your pipes. In a typical 3-bed semi-detached house, materials will cost around £20, and you will save around £3 a year on your energy bills, as well as reducing the possibility of expensive repair bills from burst pipes.
If you need an experienced, reliable and trusted boiler installation expert in Harrow offering free competitive quotes then we can help. Peter Brown Plumbing and Heating have been installing and replacing boilers since 1970. We are approved by the Gas Safe Register and are a member of the Association of Plumbing and Heating Contractors so we can ensure the quality of our work. Read our genuine customer reviews at the bottom of the page so you can read about our excellent reputation. There are a number of factors to consider before choosing a new boiler for your needs such as knowing how much hot water you use, how much space you have and so on. So the boiler you want installed will very much depend on your individual requirements and circumstances. At Peter Brown Plumbing & Heating we will advise you of your options and the most suitable central heating system for your needs. Prices for boiler replacement vary and can range from £600 to £3,000. This is dependant on many differing factors including what type of boiler it is, the size of the boiler and any additional costs that may result from the installation itself. You can read about the most popular types of boilers we install below. We also can help you save up to £300 a year with high-efficiency gas boilers. Discover extra info at https://www.peterbrown.net/new-boiler-installation-harrow.html.
Clear your radiators. Try and avoid placing large pieces of furniture in front of them. At least in the short-term, the sofa you love by the radiator is absorbing heat, says Neuburg. Putting a shelf above the radiator, especially if you have high ceilings, can also help channel the warmth, adds Neuburg. But it’s important not to place things on the radiator itself, she says, “You can put a shelf above it to stop the hot air rising directly above it.” This is particularly the case if the radiator is below a window with curtains, where warm air would be trapped between the window and the curtain. Shut up unused rooms, says Neuburg. Keeping doors closed will prevent cold air moving into the rest of the house and contain the heat you’ve generated in a smaller area.
Glow-Worm tends to sit in the category of “best of the rest”, with other boiler makes such as Vokera, and Potterton. Glow-Worm are a cheap boiler brand. They tend to be used on budget renovations and rental properties. Reliability wise, they’re certainly not known for being up there with the likes of Vaillant, Worcester, Ideal and Baxi. That said, they do offer 2 and 5 year warranties on their boilers, so in the short-term, they’re cost effective. It’s not all bad-news. Glow-Worm boilers are regularly priced as “special offers” at local plumbing merchants. So, that means they are cheap to buy, and cheap to install. Expect Glow-Worm to be priced similar to Vokera boilers, if not a little cheaper. Find even more information on https://www.peterbrown.net/.