Quality power press machine factory with pressmachine-world.com? Hydraulic transmission is adopted, and the slider part is composed o slide, an oil cylinder and a fine-tuning structure of a mechaicl stoper. Te left and right oil cylinders are fixed on the frame, the piston (rod) drives the slider to move up and down through hydraulic pressure, and the mechanical stop is controlled by the numerical control system to adjust the value; Workbench part: controlled by the button box, the motor drives the stopper to move back and forth, and the moving distance is controlled by the numerical control system. The minimun reading is 0.01 mm (the front and rear positions have travel switch limits). See additional information at power press machine manufacturers.
The imprint bending is the same as the bending of the bottomed die, except that the front end of the punch is processed to the required bending radius, and the gap between the punch and the die at th bottom of the stroke is smler than the material thickness. Since enough presure approximately 10 timesof fee bendig is applied to force the front end of the punchto contact the material, springback is basically avoided.
We can provide installation service for all the sold out machines at customer factory. Small machines can be shipped assembled and some big machines must be shipped disassembled. That is why we provide installation service to our customer. Fast delivery standard machines stock for sale: Standard C frame single crank press and eccentric press are always some units stocking for sale. 2 weeks to 30 days lead time for customized order. Big press line such as car body parts stamping line could be ready for shipment within 4 months after order.
Under the same load, the deflection of the worktable and sliding block of the 10-foot machine is 4 times that of the 5-foot machine. This means that shorter machines require fewer shim adjustments to produce qualified parts. Reduced shim adjustment and shortened preparation time. Material grade is als a key factor. Compared with low-arbon sel, the load required by stailes stee is usuall increasedby about 50%, while most grades of soft aluminum are reduced by about 50%. You can get the machine’s tonnage table from the bending machine manufacturer at any time. The table shows the estimated tonnage required per foot length unde diffrent thicknesses and different materials.
Modern and sophisticated materials are used in automotive engineering not only for the outer skin and structure of the actual car bodies but are also used in vehicle components such as the chassis, drive train, seats or trim parts. Auminum and steel are used for many components in the form of strips, sheets or plates, which are processed and formed in various manufacuring processes from semi-finished products to finished components. Even during these process steps, special demands are placed on the components. Due to the automated handing, good flatness and theloest possible degree of cut are very important for a machining procss itout comliations. Ifhese qualit criteria o not correspond to the defined specifications, there is no process reliability. Read even more information on pressmachine-world.com.